Westfield XTR2 - Rear Differential and Sprocket Installation

13.3
SECTION 13 - REAR DIFFERENTIAL & SPROCKET
Tools Required:-
- 2 x 17mm Spanners / 2 x 5/8” Spanners / 1 x 8mm Allen Key / 1 x 3mm Allen Key
Parts Required:-
- 1 x Differential Unit / 1 x Sprocket / 2 x Differential Unit Adjusters /2 x Bearing Carriers / Loctite
- 2 x 7/16” UNF x 3¼” Long Bolts / 2 x 7/16” UNF Washers & Nyloc Nuts / 2 x M10 x 55mm Long
Bolts / 6 x M10 Washers / 10 x M10 x 30mm Long Setscrews / 12 x M10 Nyloc Nuts / 2 x M10
Socket Cap Screw x 100mm Long / 4 x M10 Lock Nuts
Step 1: Assemble Differential Unit
Slide Bearing Carriers Onto Differential As Shown
Step 2: Install Differential Unit
Fit Differential Into Chassis And Fix Into Place Using The Lower Mounting Points To Begin With
50
View From Rear Of Car
Differential Unit
NOTE
T
here Are Two Grub Screws In
The End Of Each Bearing.
DO NOT Tighten At This Stage
A
s The Unit Will Be Adjusted At
A
Later Date And Fixed In Place
Using These Grub Screws.
Bearing Carriers Fitted
Chassis Bracket
Carrier Bearing