2-3
Section 2-4 - Module Configurations
The Single Circuit SAFEPATH
®
Panel is equipped with a combination of the following modules:
There are ten modules in the Single Circuit SAFEPATH
Panel product line.
The ten modules are:
SCMB (Single Circuit Motherboard)
DCPS (Power Supply/Battery Charger)
SAA-40S (40 Watt, Supervised Audio Amplifier Module with 2 Amps of strobe current)
SAA-80S/SE* (80 Watt, Supervised Audio Amplifier Module with 2 Amps of strobe current)
SALL-15S (Line Level, Supervised Audio Amplifier Module with 2 Amps of strobe current)
SC-SPL (Single Circuit Splitter - 4 Zone)
NACIM (Notification Appliance Circuit Interface Module)
MDX-2 (Digital Voice Module)
RMS-2 (Single Circuit Remote Microphone Station)
AIM-3 (Auxiliary Input Module)
* 100 Volt for Export Installations
Section 2-5 - Single Circuit SAFEPATH
®
Panel Basic Configuration
Each Single Circuit SAFEPATH
Panel is configured with:
SCMB (Single Circuit Motherboard)
MDX-2 (Digital Voice Module)
SMK (Standard Message Kit) or optional PMK (Programmed Message Kit)
One amplifier module
DCPS (Power Supply/Battery Charger)
Optional Modules:
One SC-SPL (Single Circuit Splitter-4 Zone)
Up to eight NACIM (Notification Appliance Circuit Interface Module)
Up to three RMS-2 (Remote Microphone Station)
One AIM-3 (Auxiliary Input Module)
The module layout of the Single Circuit SAFEPATH
®
Panel is shown in Figure 2-2 on Page 2-5.
Section 2-6 - Remote Microphone Station (RMS-2) (Optional)
The Remote Microphone Station (RMS-2) is a 4 gang switch-plate consisting of a push-to-talk (PTT),
hand-held microphone, pre-amplifier and associated LED’s and activation switches which provides a
remote live voice input. Additional Information is found in the Installation Manual.