7-12
5. Remove the malfunctioning module(s) and install the replacement module(s). Perform all checkout
procedures described in the “Installation” section of this manual to make sure the replacement
module(s) is (is) operating properly.
Section 7-3 – Single Circuit SAFEPATH
®
Module Wiring Diagram
Figure 7-4 on Page 7-13 illustrates the Single Circuit SAFEPATH
®
Module Wiring between modules. Note
the wires are color-coded. If major modules have been replaced or improper wiring is suspected, use this
wiring diagram to trace the proper wiring routes.
To Next Page
Loading...
Need help?
General
