5-2
2. Slide the AUTOMATIC/MANUAL switch down to the MANUAL position. The selected tone will play.
Turn off the tone by returning the AUTOMATIC/MANUAL Switch to the UP position. See Figure 5-1
on Page 5-3 for switch location.
See the Remote Microphone Station instruction sheet P83270 for additional information.
Section 5-4 - To Reset Visual Appliances
1. All activation inputs must be cleared.
2. Depress the RESET momentary switch. See Figure 5-1 on Page 5-3 for switch location.
Section 5-5 - To Acknowledge a Trouble Condition
1. Depress the TROUBLE ACKNOWLEDGE momentary switch. See Figure 5-1 on Page 5-3 for switch
location.
NOTE
:
Acknowledging a trouble condition silences the internal sounder and any external trouble
signaling devices. The system will remain in the trouble condition with the yellow TROUBLE
LED “ON”. The system trouble contact will remain in the trouble position until all trouble
conditions have been corrected. Any faults, which occur after acknowledgment, will resound the
trouble circuit.
To Next Page
Loading...
Need help?
General
