vi
Section 5-2 – To Make Live Announcements………………………………………….. 5-1
Section 5-3 – To Sound Evacuation Tone……………………………………………… 5-1
Section 5-4 – To Reset Visual Appliances……………………………………………… 5-2
Section 5-5 – To Acknowledge a Trouble Condition………………………………….. 5-2
Chapter 6 – Periodic Testing and Maintenance………………………………………………. 6-1
Section 6-1 – Periodic Testing…………………………………………………………… 6-1
Section 6-2 – Qualified Personnel..……………………………………………………… 6-1
Section 6-3 – Miscellaneous Hardware Testing ………………………………………. 6-1
Chapter 7 – Troubleshooting……………………………………………………………………. 7-1
Section 7-1 – Troubleshooting…………………………………………………………… 7-1
Section 7-2 - SAFEPATH
®
Module Replacement Procedure……………………….. 7-11
Section 7-3 – Single Circuit SAFEPATH
®
Module Wiring Diagram…………..…….. 7-12
Chapter 8 – Technical Data…………………………………………………………………….. 8-1
Section 8-1 – Mechanical……………………………………………………………….. 8-1
Section 8-2 – Environmental……………………………………………………………. 8-1
Section 8-3 – Electrical………………………………………………………………….. 8-1
Chapter 9 – Module Descriptions……………………………………………………………… 9-1
Section 9-1 – Introduction………………………………………………………………. 9-1
Section 9-2 Single Circuit SAFEPATH
®
Motherboard (SCMB)………….…………. 9-3
Section 9-3 Digital Voice Module (MDX-2)……………..………………….…………. 9-6
Section 9-4 Power Supply/Battery Charger (DCPS)…….…..………………….…… 9-8
Section 9-5 Supervised Audio System Amplifier/Signal Circuit Module, 40 Watts
(SAA-40S)…………………………………….……………………………. 9-9
Section 9-6 Supervised Audio System Amplifier/Signal Circuit Module, 80 Watts
(SAA-80S/SE)………….…………………………………………………… 9-11
Section 9-7 Supervised Audio Line Level Module (SALL-15S)…………..…………. 9-13
Section 9-8 Notification Appliance Circuit Interface Module (NACIM)………….…… 9-15
Section 9-9 4-Zone Splitter Module (SC-SPL)…………………..……………………. 9-16
Section 9-10 Auxiliary Input Module (AIM-3)……………………………….…………. 9-17
Section 9-11 Remote Microphone Station (RMS-2R)…………………………..……. 9-19
Chapter 10 – MEA and Warranty……………………………………………..……………….. 10-1
Battery Backup Calculation Sheet…………………………………………..………………… 1