WinGD X35-B - Page 4

5 Design and function of components
5.1 Group 1 - Engine frame and bearings
5.1.1 Bedplate........................................................... 134
5.1.2 Main bearing........................................................136
5.1.3 Thrust bearing...................................................... 138
5.1.4 Monoblock column...................................................140
5.1.5 Tie rod.............................................................142
5.2 Group 2 - Cylinder
5.2.1 Cylinder liner........................................................144
5.2.2 Lubricating quill..................................................... 146
5.2.3 Piston rod gland.....................................................148
5.2.4 Direct controlled injection valve........................................150
5.2.5 Starting valve.......................................................152
5.2.6 Exhaust valve.......................................................154
5.3 Group 3 - Crankshaft, connecting rod and piston
5.3.1 Crankshaft..........................................................156
5.3.2 Torsional vibration damper............................................158
5.3.3 Axial vibration damper............................................... 162
5.3.4 Turning gear........................................................164
5.3.5 Connecting rod and connecting rod bearing.............................166
5.3.6 Crosshead and guide shoe........................................... 168
5.3.7 Piston..............................................................170
5.4 Group 4 - Supply unit drive and control components
5.4.1 Supply unit drive.................................................... 172
5.4.2 Starting air shut-off valve.............................................174
5.4.3 Control air supply....................................................176
5.4.4 Local maneuvering stand.............................................178
5.4.5 Pick-up for speed measurement.......................................180
5.5 Group 5 - Supply unit, pumps and control valves
5.5.1 Servo oil pump......................................................182
5.5.2 Supply unit......................................................... 184
5.5.3 Fuel pump..........................................................186
5.5.4 Pressure control valve............................................... 188
5.5.5 Flow limiting valve...................................................190
5.5.6 Exhaust valve control unit............................................ 192
5.6 Group 6 - Scavenge air components
5.6.1 Scavenge air receiver................................................194
5.6.2 Turbocharger....................................................... 196
5.6.3 Auxiliary blower..................................................... 198
5.6.4 Auxiliary blower switch box........................................... 200
5.6.5 Scavenge air cooler..................................................202
5.6.6 Water separator.....................................................204
X35-B
Operation Manual
Winterthur Gas & Diesel Ltd.
- 4 - Issue 001 2019-10