Winkhaus blueMatic EAV - Page 45

Notice: If you plan installations on a metal substructure, you will
have to use a timber board and spacer bolts, if applicable, or
large bore holes to ensure the proper function of the antenna!
To test the scanning performance, you may have to tentatively
install it on site, if applicable!
504474445
3
EN
Aug. Winkhaus GmbH & Co. KG ∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.de ∙ Subject to technical changes
blueMatic EAV Installation, Operating and
Maintenance Instructions
• Connect the cable of the antenna (fixed in the antenna) to the reader/control
unit.
• Recommendation: Lay a reserve pipe from the antenna to the reader unit.
Figure 3.4-1: Terminal assignment of the transponder reader
No. Terminals
 red  V DC
 black  V DC
 serial interface
 serial interface
 white Antenna
 white
Antenna
 green potential free contact C
 green potential free contact NO