48 M101H Series User Guide
User can define specific characters to be replaced with preferred
characters automatically. When the characters defined in Regex
Substitution is scanned, the data will be replaced with the one
filled in Replace with.
User can remove all the set up and back to default mode.
SDK
For users following SDK for software porting, the scanned data can also be output with
the format needed.
Virtual COM
User can also choose Virtual COM to transfer scanned data to the defined COM port.
User can tap on the Disconnect button to stop the connection with Barcode Reader.
*To recover the connection, please tap on the button again to re-connect with Barcode
Setting the 1D/2D Barcode Scanner Symbologies
The barcode scanner is shipped with default settings shown below. If the default setting
suits the usage requirement, setting symbologies is not necessary.
To Next Page
Loading...
