Winmate M101H - Page 79

M101H Series User Guide 77
sensor are enabled in Control Panel.
• The tablet computer may be out of coverage
area. Move your tablet computer outdoors or
closer to a window.
• Check if your surroundings have interferences,
such as microwave ovens, cordless phones.
Move the tablet computer away from objects
causing interference.
No sound is produced.
• Adjust volume of the tablet computer by
pressing on the volume rocker.
• If using an external audio device, make sure
that the cable is properly connected.
I cannot project the tablet computer display
to another monitor.
• Make sure the VGA driver is installed.
• Make sure the output setting selected is
correct.
Barcode scanner does not emit laser beam
and does not seem to work.
• Make sure the Barcode scanner device is
enabled in Hottab utility.
• Make sure under Windows, the Barcode
Reader is set to COM 15 port, so that Hottab
can trigger the Barcode Reader hardware.
Barcode Scanner emits laser beam but does
not read barcode presented to it.
• Adjust the distance between barcode scanner
of the device and the barcode being scanned.
• Make sure the barcode code type is enabled in
the tablet. To enable/disable a specific
barcode code type, go through the “Barcode
Scanner Configuration” section.
I am having GPS accuracy issue
• When utilizing the GPS function, we
recommend disabling the Barcode Reader in
Hottab to reduce interference.
RFID scanner does not seem to work.
• Make sure under Windows, the RFID
hardware is set to COM 3 port.