Wizard CMC 9000 - Check Contents; Equipment Required; Where to Find more Information; Knowledge Base

Wizard CMC Model 9000 Hardware and
Software Getting Started Guide
Check Contents
Review equipment upon arrival for shipping damage. Contact Wizard if any damage is noticed. Verify that the
contents shown in the packing slip are received. Please save the packaging.
Equipment Required
The CMC Stand or wall mount - must be assembled rst before unpacking the Wizard™ CMC (Computerized Mat Cutter)
Electrical outlet
Air source - You will need an air compressor that supplies between 100psi and 120psi.
Surge protector
Table for the computer/monitor
Where to Find More Information
Knowledge Base
The online help and Knowledge Base contains a wide assortment of searchable documentation and
information which can be found at:
• FrameShop Software Online Help: https://wizardcutters.atlassian.net/wiki/x/7g4qYw.
• 9000 Hardware information can be found on the Knowledge Base: https://wizardcutters.atlassian.net/
wiki/x/dIAD.
Website
Check out the Wizard website at www.wizardcutters.com for additional information.
4
Wizard™ International, Inc., 4600 116th St. SW, Mukilteo, WA 98275 888/855-3335 wizardcutters.com
20-34300-1A GettingStartedManual9K-70FrameShop
02/23/24
Wizard™ CMC Model 9000 Hardware and Software Getting Started Guide