Wizard CMC 9000

To Next Page

To Previous Page

Start Up the Computer ............................................................................................14

Launch FrameShop .................................................................................................14

Creating Your First Mat ................................................................................................14

Edit New Mat ............................................................................................................14

Cut Your First Mat .........................................................................................................16

Prepare to Cut ...............................................................................................................18

Homing and Alignment ........................................................................................... 18

Cartridge Change and Depth Setting ....................................................................19

Create Another Mat ......................................................................................................19

Select a Di󰀨erent Template ....................................................................................19

Blade Depth Settings ...................................................................................................22

Variable Pressure Optimization (VPO) Feature..........................................................22

Adjusting for Regular or Dense Matboard ............................................................22

Cutting an Extra Dense Layer with the 90° Cartridge .......................................... 24

Changing the Blade ......................................................................................................25

Using the 45º Cartridge ..........................................................................................25

Using the Pen Cartridge .........................................................................................25

Blades and Cartridges ............................................................................................26

Aborting a Cut ...............................................................................................................26

Troubleshooting ...........................................................................................................26

Frequently Asked Questions ....................................................................................... 27

Hardware Maintenance ................................................................................................28

Maintenance Schedule ...........................................................................................28

O󰀪oad Air Regulator ..............................................................................................29

Disclaimers ...................................................................................................................29

Wizard™ International, Inc.

4600 116th Street Southwest

Mukilteo, WA 98275-0066 USA

For information on our products and services or for technical support call Wizard at 1-888-855-3335 or visit us

at www.wizardcutters.com

This product and its documentation are protected by copyright and are distributed under license restricting its use, copying, distribution

and decompilation. No part of this software product may be copied, reproduced or disassembled without written permission from Wizard

International, Inc. and its licensors, if any.

Trademarks: FrameShop™ is a trademark of Wizard International, Inc.

DOCUMENTATION IS PROVIDED “AS IS” AND ALL EXPRESS OR IMPLIED CONDITIONS, REPRESENTATIONS, AND

WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR NON-

INFRINGEMENT, ARE DISCLAIMED, EXCEPT TO THE EXTENT THAT SUCH DISCLAIMERS ARE HELD TO BE LEGALLY INVALID.

20-34300-1A GettingStartedManual9K-70FrameShop

02/23/24

Wizard CMC Model 9000 Hardware and Software Getting Started Manual

Wizard™ CMC Model 9000 Hardware and Software Getting Started Guide

Wizard CMC 9000 - Page 3