Wizard Z1 - Wizard CMC Model Z1; Check Contents; Equipment Required; Where to Find more Information

Wizard CMC Model Z1 Hardware and
Software Getting Started Manual
Check Contents
Review equipment upon arrival for shipping damage. Contact Wizard if any damage is noticed. Verify that the
contents shown in the packing slip are received. Please save the packaging.
Equipment Required
The CMC Stand must be assembled rst before unpacking the Wizard™ CMC (Computerized Mat Cutter)
110 Volt Electrical outlet
Air source - You will need an air compressor that supplies between 100psi and 120psi.
Surge protector
Table for the computer/monitor
Where to Find More Information
Knowledge Base
The online help and Knowledge Base contains a wide assortment of searchable documentation and The online help and Knowledge Base contains a wide assortment of searchable documentation and
information. They can be found at:information. They can be found at:
• • FrameShop Software Online Help: FrameShop Software Online Help: https://wizardcutters.atlassian.net/wiki/x/hgApYw. .
• • Z1 Hardware information can be found on the Knowledge Base: Z1 Hardware information can be found on the Knowledge Base: https://wizardcutters.atlassian.net/
wiki/x/dIAD..
Website
Check out the Wizard website at Check out the Wizard website at www.wizardcutters.comwww.wizardcutters.com for additional information. for additional information.
4
Wizard™ International, Inc., 4600 116th St. SW, Mukilteo, WA 98275 888/855-3335 Wizard™ International, Inc., 4600 116th St. SW, Mukilteo, WA 98275 888/855-3335 wizardcutters.comwizardcutters.com
20-36070-1 GettingStartedManualZ1-70FrameShop
04/03/24
Wizard™ CMC Model Z1 Hardware and Software Getting Started Guide