Wizard Z1 - Launch Frameshop; Creating Your First Mat; Edit New Mat

Launch FrameShop
Double-click on the FrameShop icon to start the software. Double-click on the FrameShop icon to start the software.
Creating Your First Mat
Edit New Mat
1. Click 1. Click New Mat New Mat
DesignDesign on the main on the main
screen to create a new screen to create a new
design. design.
2. Stay on the 2. Stay on the SingleSingle
tab. There are three tab. There are three
tabs to select from: tabs to select from:
SingleSingle, , MultiMulti, and , and
ArrayArray..
Opening Size
1. Enter 5x7 (approx. 13x18 cm) for the width and height of 1. Enter 5x7 (approx. 13x18 cm) for the width and height of
the opening. the opening.
NOTE: NOTE: The Outside size eld will display on the top if The Outside size eld will display on the top if
Edit Opening Size FirstEdit Opening Size First is unchecked in the is unchecked in the Admin > Admin >
DefaultsDefaults..
Optionally, enter the outside dimensions rst.Optionally, enter the outside dimensions rst.
Borders
1. Enter 2 (approx.1. Enter 2 (approx. 5 cm) for the 5 cm) for the bottombottom, , toptop and and
sideside mat border widths. mat border widths.
20-36070-1 GettingStartedManualZ1-70FrameShop
04/03/24
15
Wizard CMC Model Z1: Hardware and Software Getting Started Manual
Wizard™ CMC Model Z1 Hardware and Software Getting Started Guide