WMF 2000S - Page 66

66
User Manual WMF2000S
Appendix: Technical data
Mains voltage tolerance range 230V +6 % and–10 % / 400V +6 % and–10 %. Mains voltage
interruption < 50ms: no interruption of function
Water supply
(Constant water supply
optional)
3/8inch hose connector with mains tap, and filter with 0.2to
0.25mm mesh size, on site. Min. 0.2MPa flow pressure at
2litres/minute, max. 0.6MPa. Water temperature max.
35°C.
The set of hoses provided with the new coffee machine and/
or the new water filter must be used. Do not use old hoses.
Water quality For drinking water with carbonate hardness above 5 °dKH,
aWMFwater filter should be fitted upstream.
Water drain tube Tube aminimum of DN 19, minimum downward slope of
2cm/m
Ambient temperature +5°C to max. +35°C (empty the water system in case of
frost).
Maximum humidity 80 % relative humidity without condensation.
Do not use device outdoors.
Degree of protection IP X0
Installation surface The device must be placed on alevel, flat, and sturdy surface.
The device is not intended to be located on asurface that
is sprayed or cleaned with awater hose, steam jets, steam
cleaner, or similar devices.
Installation clearances For operating, service and safety reasons the machine should
be installed with aclearance of not less than 50mm at the
back and sides from the building or non-WMFcomponents.
Aminimum working space of 800mm in front of the coffee
machine is recommended. Aclear height of 1,100mm from
the top of the supporting surface should be ensured. The
height of the installation surface above the floor is at least
850mm. If the coffee machine connections are to be run
downwards through the counter, please make space for the
lines, which can reduce the usable space below the machine.
Installation dimensions of the
water filter
See the User Manual for the water filter.
These specifications for the electrical connection and the standards quoted apply for connecting
the coffee machine in EU countries. It may be necessary to also observe additional country-specific
regulations. Outside the EU countries, acceptance of the standards quoted is to be checked by the legal
entity or natural person who wishes to use the coffee machine.