Operation
30
Tip: Milk or milk foam can drip a little after dispensing. It is best to hold your cup for a little while longer
after dispensing under the All-In-One spout, or place a small collecting vessel under the spout.
Tip: Milk can also drip, if the milk container is full and at the same time the All-In-One spout is in a lower
position. Push the spout slightly upwards after the beverage is dispensed.
3.3.8 Hot water dispensing
You can dispense hot water, for example, for tea, with the help of hot water function.
> Place a suitable drinking vessel under the hot water spout.
> Briefl y press the hot water button to obtain one glass of hot water.
For obtaining hot water in variable quantities:
> Press and hold the hot water button till the desired quantity of hot water is prepared.
3.4 Cancel beverage preparation
You can cancel the current beverage dispense:
> Press
C
button.
For beverages with more than one component such as coffee and milk:
> Press the beverage button once again to cancel the active dispense.
The next component is dispensed.
To Next Page
Loading...
