Operation
37
3.6.3 Basic settings
Following settings can be adjusted:
Basic settings
Language* Water hardness*
Energy saving modes* Water fi lter*
Time* Special information tone
Date* Brewing temperature
Display of time/date Factory settings
Switch on time Display contrast
Switch off time*
The basic settings marked with a * have already been set during the commissioning. However, you can subsequently change these values too.
The description for this can be found under the chapter “2 Initial setup” on page 7.
In order to adjust the basic settings, proceed as follows:
> Press
P
button.
> Browse with
+
for basic settings.
Select program
browse: +
Select the basic
settings
To Next Page
Loading...
