EasyManua.ls Logo

Wolf 2 Series - Installation Dimensions by Model

Wolf 2 Series
62 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Electric Cooktop -2
Installation Information
2-4
Installation Dimensions (CT15E )
NOTE: For complete installation information, please refer to
the Installation Guide provided with the unit.
This cooktop is designed to t a standard 24” (610 mm)
width base cabinet with a 25” (635 mm) deep counter top.
Figures 2-3, 2-4 provide installation speci cations for the
Model CT15E. If a shelf is installed below the unit, a 1”
(25mm) gap at the rear of the cabinet shelf is necessary to
allow for proper ventilation. Failure to do so could result in
decreased performance or product damage.
NOTE: Locate the junction box within reach of the 48”
(1219 mm) conduit, and accessible when the cooktop unit
is installed.
NOTE: Do not block the cooling fan located at the bottom
of the cooktop. Minimum 5 3/4” (146mm) clearance is
required between countertop and any combustible surface
directly below the cooktop.
Figure 2-3 CT15E Counter top Cut-Out Top View
WIDTH
(64)
COOKTOP CUT-OUT
13-3/8” (340)
COOKTOP
DEPTH
CUT-OUT
19-1/4” (489)
2-1/2” MIN
FRONT OF COUNTERTOP
NOTE: Application shown allows for installation of two 15” (381mm) modules side-by-side with 33” (838mm)
recommended cabinet width. 18” (457mm) recommended cabinet width for installation of single 15” (381mm) cooktop
or module. *Minimum clearance from both side edges of cooktop cut-out to combustible materials up to 18” (457mm)
above counter top. **Minimum clearance from rear edge of cooktop cut-out to combustible materials up to 18” (457mm)
above counter top.
NOTE: If the cooktop is to be used with any combination of additional cooktops or modules with a ller strip, the cut-out
width increases to 14” (356mm).
NOTE: Unit dimensions may vary to ±1/8” (3mm).
Figure 2-4 CT15E Counter top Cut-Out
E
4”
(102)
15"
(381)
15"
(381)
2"* min (51)
13-3/8”
(340)
WIDTH
33" (838)
RECOMMENDED
CABINET WIDTH
18"
(457)
19-1/4” (489)
2-1/2” min
(64)
36" (914)
FLOOR TO
HEIGHT
13" max
(330)
30" (762)
2"**
(51)
STANDARD
COUNTER
CUT-OUT
COUNTERTOP TO
COMBUSTIBLE
MATERIALS
ABOVE COOKTOP
CUT-OUT TO
COMBUSTIBLE
MATERIALS
BOTH SIDES
COOKTOP
CUT-OUT
DEPTH
NOTE: Installations of International units require taking
the extra space required for the Terminal Box into
consideration.

Other manuals for Wolf 2 Series

Related product manuals