Electric Cooktop -2
Access & Removal
4-2
TO AVOID ELECTRIC SHOCK, POWER TO THE UNIT MUST BE DISCONNECTED WHENEVER SERVICING
AND/OR ACCESSING COMPONENTS.
KEEP IN MIND THAT GLASS TOP SURFACES AND COMPONENTS GET HOT DURING USE OF THE
APPLIANCE.
IF IT IS NECESSARY TO REMOVE A UNIT FROM ITS INSTALLATION, REMEMBER THAT THE UNITS
ELECTRICAL POWER CORD IS HARD WIRED AND COMPLETE REMOVAL WILL BE LIMITED. PULLING A UNIT
FROM ITS INSTALLATION SHOULD ONLY BE PERFORMED BY AN AUTHORIZED SERVICE TECHNICIAN OR
INSTALLER.
When working on the cooktop and components, be careful when handling sheet metal parts.
There may be sharp edges present.
COMPONENT ACCESS AND REMOVAL
This section explains how to access and remove components from a Wolf electric -2 cooktop. Depending on which
component you are going to access or remove in the following sections, you may have to remove some components
fi rst. Refer to the appropriate section in this manual that explains how to access and remove those various components.
When reassembling, reverse the steps that were used to access and remove the components.
NOTE: Before attempting to access or remove any components from a Wolf appliance, take note of the
WARNINGS and CAUTIONS below.
NOTE: Changing the wire routing can result in unit damage.
Major Serviceable Components:
Glass Ceran top includes Keypad•
Power Module•
Fan Assembly•
Heating Elements•
To Next Page
Loading...
