74 3064298_201507
Systemconguration33
SColS
SCP
FT
RTS
Separating cylinder
Heating circuit
HCP
Circuit with mixer
MCP
MaxTh
FS
MM
A 3-way diverter valve for
central heating/DHW and
a feed/heating circuit pump
are integrated into the
indoor module
Indoor module
Outdoor module
Solar DHW cylinder
Please note:
Header temperature sensor HTS must be
installed in the return area of the low loss
header or separating cylinder.
HTS
Extension options
CGB-2
BWL-1S(B)
● Split air/water heat pump
● Separating cylinder
● Solar DHW cylinder
● CGB-2
● Heating circuit
● Extension, circuit with mixer, with MM
● Solar circuit extension with SM1
● DHW heating
● Alternatively, dual mode operation only is possible
Important information:
In this schematic diagram, shut-off valves, air vent valves and safety equipment are not fully represented.
These should be provided for each individual system, in line with the applicable standards and regulations.
Hydraulic and electrical data can be found in the Hydraulic System Solutions technical guide.
To Next Page
Loading...
