Sawmill Assembly
Uncrating the mill
3
3-3 WMdoc122320 Sawmill Assembly
5. Remove and inspect the parts boxes.
WARNING! Leave the blade in its box until you have reviewed the
video on safe blade handling. Failure to follow this may result in seri-
ous injury or death.
See Figure 3-3.
The Power Feed motors and one motor mount are packaged separately. The second
Power Feed motor mount is bolted on the exterior of the bed frame sections.
FIG. 3-3
TABLE 1: PARTS BOX CONTENTS
Part # Description Qty
Kohler Engine Manual 1
Hardware bag
1
F05004-250 Bolt, M12x1.75x40mm HH FT
CL10.9 Zinc
6
F05011-124 Washer, M12 FLAT Zinc 12
F05010-209 Nut, M12x1.75 Hex Nylock 6
115110 Shim, End Stop 4
115290 Chain, #40x460 Pitches (230”) 2
115106 End Stop Right 2
115112 End Stop Left 2
015721 Tensioner Wldmt, Power Feed
Chain (on End Stops)
4
128014 Bed Shim, LX250 16Ga 22
128015 Bed Shim, LX250 16Ga 22
128016 Bed Shim, LX250 7Ga 11
To Next Page
Loading...
