Sawmill Assembly
End Stop Assemblies
3
3-9 WMdoc122320 Sawmill Assembly
See Figure 3-11.
14. Repeat steps 2 through step 13 for the last bed section.
3.4 End Stop Assemblies
NOTICE: The end stops (bumpers) are left/right oriented.
1. Mount the end stops to the frame with the shims between the frame and the end stops.
See Figure 3-12.
3.5 Adjusting/leveling the Bed
NOTE: Adjusting/leveling the log bed is best done before the saw head
is installed.
FIG. 3-11
FIG. 3-12
Shim
F05004-97, M10 bolt
F05011-134, M10 flat washer
F05004-270, M10 nylok nut
115110, Shim
To Next Page
Loading...
