Sawmill Alignment
Blade Guide Re-installation
9
9-14 WMdoc042021 Sawmill Alignment
See Figure 9-13.
8. If necessary, adjust the drive-side blade wheel to position the blade as shown in Figure
9-12.
NOTE: To move the blade back onto the blade drive wheel, loosen the
right adjustment screw one quarter turn. Loosen the jam nut on the left
adjustment screw and tighten the screw. Tighten the left and right jam
nuts.
To move the blade out on the wheel, loosen the left adjustment screw
one quarter turn. Loosen the jam nut on the right adjustment screw and
tighten the screw. Tighten the left and right jam nuts.
Blade Guide Re-installation
NOTE: Before re-installing the blade guide assemblies, remove the
blade guide adjusting screws and apply a lubricating oil such as
10W30 or Dexron III to each screw. This will prevent the screws and
threaded holes from corroding and make screw adjustments easier.
1. Position outer blade guide assembly (with waterlube tube) to the mounting block on the
blade guide arm so the that roller flange is 1/8" (3.0 MM) from the blade.
2. Position the inner blade guide assembly to the mounting block on the saw head so that
the roller flange is 1/16" (1.5 MM) from the blade.
3. Tighten the two previously-loosened tilt adjustment screws to secure the blade guide
assembly.
FIG. 9-13
Drive Side
Idle Side
To Next Page
Loading...
