Sawmill Setup
Tensioning The Blade
4
4-3 WMdoc122320 Sawmill Setup
4.2 Tensioning The Blade
1. Use the supplied handle to turn the tensioner handle clockwise until the tension gauge
indicates 1500-1700 PSI tension.
See Figure 4-2.
2. Check the blade tension when adjusting the cant control or making other adjustments.
NOTE: Check the blade tension after prolong use. The blade and belts
heat up and stretch, the blade tension will change.
3. Check the blade tension when there are changes in the ambient temperature.
4.3 Tracking The Blade
WARNING! Do not spin the blade wheels by hand. Failure to follow
this may result in serious injury.
FIG. 4-2
Tensioner handle
Tensioner handle
(storage area)
Tension gauge
Normal operation:
1500-1700 PSI
To Next Page
Loading...
