Wood-mizer LX250 - Simple Set Up;Down Gear Settings Adjustment

Simple Set Up/Down Gear Settings Adjustment
8
8-2 WMdoc122320
NORMAL OPERATION:
 As the up/down gearbox shaft spins to move the saw head up or down, the sensor
LED will illuminate and brighten.
After each complete revolution of the shaft, the LED will turn off, then illuminate and
brighten.
MANUAL MODE
 In manual mode, the control board LED and the H-bridge D2, D3, D4 LEDs will illu-
minate (red) when the drum switch is activated in the down direction and (green)
when the up/down drum switch is activated in the up direction.
The LEDs will turn off when the drum switch is released.
The H-bridge D8 LED will illuminate blue to indicate the 5 Volt DC output to the con-
trol board.
AUTO MODE
 In auto mode, the control box LED and the H-bridge D2, D3, D4 LEDs will illuminate
(green) in the up direction as in manual mode.
When the drum switch is bumped in the down direction, the control box LED and the
H-bridge D2, D3, D4 LED’s will illuminate (red) in the down direction but the control
board LED will immediately turn off.
When the blade reaches the increment value set by the Simple Set control, the D2,
D3, D4 LEDs on the H-bridge will turn off.
If the drum switch is held down or the saw head coasts past the increment, the
H-bridge D2, D3, D4 LEDs will illuminate (green) indicating the blade will move up to
return to the increment value.
When the blade reaches the increment value, the H-bridge D2, D3, D4 LEDs will
turn off.
Simple Set Up/Down Gear Settings Adjustment
1. Make sure the power to the control box is on.
2. Press and hold the Manual button and then press and hold the UP button
3. Release the Manual button, then release the UP button
The Simple Set control panel will display the Speed setting.