Sawmill Assembly
Feed Drive Assembly
3
3-11 WMdoc122320 Sawmill Assembly
NOTE: There should be no more than an 1/8” clearance between the
mast safety assembly and the bed rail.
5. Ensure the white rail wipers make firm contact with the rails: the wiper mounting plate
should not set on the rail.
See Figure 3-14.
3.7 Feed Drive Assembly
1. Unpack the Power Feed drive assemblies from the boxes, and retrieve the mount assem-
bly set aside in section 3.3, step 1.
2. Thread the Power Feed chain through the sprockets.
FIG. 3-14
Transport position
Operating position
>1/8” (3mm)
clearance
Wiper and wiper mount
located both front and
rear on both right and left
roller assemblies.
To Next Page
Loading...
