Sawmill Setup
Starting The Engine
4
4-9 WMdoc122320 Sawmill Setup
INNER BLADE GUIDE
6. Ensure that the distance between the flange on the inner blade guide roller to the back
edge of the blade measures to 1/16" (1.5 mm). See Figure
4-8.
7. Adjust the roller back or forward, as described above.
4.5 Starting The Engine
DANGER! Always be sure the blade is disengaged and all persons are
out of the path of the blade before starting the engine or motor. Failure
to follow this will result in serious injury
WARNING! Make sure all guards and covers are in place and secured
before operating the sawmill. Failure to follow this may result in serious
injury.
Electrical systems will run with the key in the Accessories (3) position; however, you risk
running your battery down.
See the manual supplied with your specific engine/motor configuration for starting and
operating instructions.
See Figure 4-9.
FIG. 4-9
OFF
START
RUN
Accessories
To Next Page
Loading...
