Wood-mizer LX250 - Default Chapter; Table of Contents

Table of Contents Section-Page
Table of Contents LX250 4/16/21 iii
SECTION 1 INTRODUCTION 1-1
1.1 About This Manual.................................................................................1-1
1.2 Getting Service .......................................................................................1-1
1.3 Specifications .........................................................................................1-1
1.4 Customer and Sawmill Identification.....................................................1-1
1.5 Specifications .........................................................................................1-2
LX250 Dimensions ................................................................................. 1-3
SECTION 1 GENERAL SAFETY 2-1
1.1 Safety Symbols.......................................................................................2-1
1.2 Safety Instructions..................................................................................2-1
Observe ALL Safety Instructions............................................................ 2-1
1.3 Electrical Lockout Procedures................................................................2-3
SECTION 3 SAWMILL ASSEMBLY 3-1
3.1 Tools required.........................................................................................3-1
3.2 Uncrating the mill...................................................................................3-1
3.3 Assemble the bed....................................................................................3-4
3.4 End Stop Assemblies..............................................................................3-9
3.5 Adjusting/leveling the Bed.....................................................................3-9
3.6 Saw Carriage Assembly .......................................................................3-10
3.7 Feed Drive Assembly ...........................................................................3-11
SECTION 4 SAWMILL SETUP 4-1
4.1 Installing the Blade.................................................................................4-1
4.2 Tensioning The Blade.............................................................................4-3
4.3 Tracking The Blade ................................................................................4-3
4.4 Sawblade.................................................................................................4-6
Blade Guide Vertical Tilt Alignment...................................................... 4-6
Blade Guide Flange Spacing ................................................................. 4-7
4.5 Starting The Engine................................................................................4-9
SECTION 5 SAWMILL OPERATION 5-1
5.1 Manual Power Feed................................................................................5-1
5.2 Manual Up/Down Operation ..................................................................5-3
5.3 Up/Down (Simple Set Operation) ..........................................................5-3
Changing the Default Setup .................................................................. 5-4
Operation .......................................................................................... 5-5
5.4 Loading, Turning, & Clamping Logs.....................................................5-6
5.5 Blade Guide Arm Operation...................................................................5-8
5.6 Cutting The Log .....................................................................................5-9
5.7 Edging...................................................................................................5-10
5.8 Blade Height Scale ...............................................................................5-11