Wood-mizer LX250 - SECTION 5 SAWMILL OPERATION; 5.1 Manual Power Feed

Sawmill Operation
Manual Power Feed
Sawmill Operation WMdoc041621 5-1
5
SECTION 5 SAWMILL OPERATION
5.1 Manual Power Feed
The power feed system moves the mast forward and backward by using the two switches
on the control panel illustrated below.
See Figure 5-1.
MAST FORWARD AND REVERSE
The mast forward/reverse drum switch controls the direction in which the mast travels.
The middle position (as shown) is the neutral position. The power feed switch is designed
to return to the neutral or "off" position when released from operating in the reverse posi
-
tion. If the switch remains engaged, manually move the switch to the neutral or "off" posi-
tion and See Section 5.6.
WARNING! Ensure the power feed switch is in the neutral position
before turning the key switch to the on (1) or accessory (3) position to
prevent accidental mast movement. Failure to follow this will result in
death or serious injury.
FIG. 5-1
LX0017-2
Forward
Reverse
Slow
Fast
Drum Switch
Handle