Sawmill Setup
Installing the Blade
Sawmill Setup WMdoc122320 4-2
4
See Figure 4-1.
3. Place the new blade around the blade wheels.
NOTE: When installing a blade, make sure the teeth are pointing the
correct direction. The teeth should be pointing toward the operator side
of the mill when you are looking at the blade below the blade guides.
4. Position 1 1/4” wide blades (standard) on the wheels so the gullet is 1/8" (3.0 mm) out
from the edge of the wheel.
FIG. 4-1
Tensioner handle
Tensioner handle
(storage area)
To Next Page
Loading...
