Manual 26710V1 ProTechTPS Total Protection System
Woodward 9
Measurement inputs are classified as permanently connected IEC
measurement Category I and are designed to safely withstand
occasional transient overvoltages up to 1260 Vpk. To avoid the
danger of electric shock, do not use these inputs to make
measurements within measurement categories II, III, or IV.
Explosion Hazard—Do not connect or disconnect while circuit is live
unless area is known to be non-hazardous.
Substitution of components may impair suitability for Class I,
Division 2 or Zone 2 applications.
Risque d’explosion—Ne pas raccorder ni débrancher tant
que l’installation est sous tension, sauf en cas l’ambiance
est décidément non dangereuse.
La substitution de composants peut rendre ce matériel
inacceptable pour les emplacements de Classe I,
applications Division 2 ou Zone 2.
Safety Symbols
Both direct and alternating current
Alternating current
Direct current
Caution, risk of electrical shock
Caution, refer to accompanying documents
Protective conductor terminal
Frame or chassis terminal
To Next Page
Loading...
