Satellite Upconverter Manual WORK Microwave
18 / 49 V151207
2.7.11 Reference Signal Input
At the “Ref. In” connector (BNC, 50 W, female) an external reference signal can be connected. The frequency
can be either 10 MHz or 5 MHz. See chapter 3.5.2.7 for configuration options and details about this input.
2.7.12 IF Input Connector
The IF input signal is connected to the “IF In” connector at the rear panel. The type of connector is BNC,
50 Ohm or SMA (720 MHz IF), 50 Ohm, female. With dual channel devices, two IF inputs are available.
2.7.13 Ground Terminal
The ground terminal is a blade type connector with the width 6.3 mm.
Important: For save operation, this ground terminal must be permanently connected to a grounding
point!
To Next Page
Loading...