Satellite Upconverter Manual WORK Microwave
7 / 49 V151207
1 Introduction
1.1 Application
The Upconverters from WORK Microwave are utilized in modern satellite communication and broadcasting
systems.
This document describes the functions, the installation and the monitoring and control interfaces (M&C) of the
Upconverters.
1.2 Reference Documents
The Upconverters of WORK Microwave are designed in correspondence with the following references and
standards:
EN 55022
EN 61000-6-2
EN 61000-6-3
EN 60950-1
IEEE 802.3
Universal Serial Bus Specification Revision 2.0
1.3 Reference to Firmware Versions
This issue of the user manual applies to the front panel base firmware version XNA01.58 or higher and the
front panel device firmware version FCA01.50.
The front panel base firmware version and the front panel device firmware version are shown immediately
after booting for approx. 2 sec. in the display. The firmware versions can also be queried by the front panel
menu: “SYSTEM CFG / FIRMWARE VERSIONS” or by the remote access.
1.4 Abbreviations
AC Alternating current
BNC Bayonet Neill Concelman
DC Direct Current
EQ Equalization
HTTP Hypertext Transfer Protocol
HTTPS Hypertext Transfer Protocol Secure
IC Integrated Circuit
IF Intermediate Frequency
IP Internet Protocol
LCD Liquid Crystal Display
LED Light-Emitting Diode
LNA Low Noise Amplifier
LNB Low Noise Blockconverter
LO Local Oscillator
M&C Monitoring & Control
MAC Media Access Control
MIB Management Information Base
MPT Multipoint
MW Microwave
NTP Network Time Protocol
OCXO Oven-Controlled Crystal Oscillator
ODU Outdoor Unit
OID Object Identifier
OS Operating System
PLL Phase-Locked Loop
PLO Phase-Locked Oscillator
Ref. Reference
RF Radio Frequency
RX Receiver
SNMP Simple Network Management Protocol
TCP Transmission Control Protocol
TCXO Temperature Controlled Crystal Oscillator
TX Transmitter
UDP User Datagram Protocol
USB Universal Serial Bus
VFD Vacuum Fluorescent Display
VHF Very High Frequency
XML Extensible Markup Language
To Next Page
Loading...