Satellite Upconverter Manual WORK Microwave
47 / 49 V151207
5 Maintenance and Service
5.1 Maintenance
Under standard conditions there are no parts inside the Converter which need any maintenance.
The only part inside the Unit, which may be readjusted is the reference oscillator. This is only necessary un-
der operation conditions with a very high demand for frequency accuracy and if these component has moved
in frequency after some period of time. In this case please contact the factory.
The fuses for the mains supply voltage are integrated in the mains connector on the rear panel.
5.2 Service
If a fault occurs with the device we kindly ask you to report the following to the factory support:
· Model number and serial number
· Time in operation
· Description of failure
Please note the status in the front panel status display. Please note also the current configuration or leave the
settings unchanged.
If the unit shall be returned to the factory please copy and fill out the RMA (return material authorization) re-
quest form, see chapter 5.4. Please fax or send this form to the address which you find on the form. You will
then receive an RMA number which allows easier equipment tracking.
5.3 Company Address
WORK Microwave GmbH
Raiffeisenstrasse 12
83607 Holzkirchen
Germany
Tel. +49 8024 6408 0
Fax +49 8024 6408 40
E-Mail sales@work-microwave.com
To Next Page
Loading...