Satellite Upconverter Manual WORK Microwave
9 / 49 V151207
5.
6. Never use the product if the power cable is damaged. Check the power cable on a regular
basis to ensure that it is in proper operating condition.
7. Do not insert the plug into sockets that are dusty or dirty. Insert the plug firmly and all the way
into the socket. Otherwise, sparks that result in fire and/or injuries may occur.
8. Do not overload any sockets, extension cords or connector strips; doing so can cause fire or
electric shocks.
9. Never remove the cover or any part of the housing while the product is in operation. Doing so
will expose circuits and components and can lead to injuries, fire or damage to the product.
10. Use suitable overvoltage protection to ensure that no overvoltage (such as that caused by a
bolt of lightning) can reach the product. Otherwise, the person operating the product will be
exposed to the danger of an electric shock.
11. Unless specified otherwise, products are not liquid-proof. Therefore, the equipment must be
protected against penetration by liquids. If the necessary precautions are not taken, the user
may suffer electric shock or the product itself may be damaged, which can also lead to per-
sonal injury.
12. Never use the product under conditions in which condensation has formed or can form in or
on the product, e.g. if the product has been moved from a cold to a warm environment. Pene-
tration by water increases the risk of electric shock.
13. Prior to cleaning the product, disconnect it completely from the power supply. Use a soft,
nonlinting cloth to clean the product. Never use chemical cleaning agents such as alcohol,
acetone or diluents for cellulose lacquers.
· Operation and environmental
1. The predefined operating position is always with the housing floor facing down
2. Operating the products requires special trained persons.
3. It is the responsibility of the employer/operator to select suitable personnel for operating the
devices.
4. Should a fire occur, the product may release hazardous substances (gases, fluids, etc.) that
can cause health problems. Therefore, suitable measures must be taken, e.g. protective
masks and protective clothing must be worn.
5. Do not use the equipment in an environment in which the unit is exposed to:
§ Unpressurised altitudes higher than 2000 meters
§ Extreme temperatures outside the stated operating temperature range
§ Excessive dust
§ Moist or humid atmosphere above 95 % RH (non condensing)
§ Excessive vibration
§ Flammable gases
§ Corrosive or explosive atmospheres
§ Direct sunlight
· Repair and service
1. The product may be opened only by authorized, specially trained personnel. Before any work
is performed on the product or before the product is opened, it must be disconnected from
the AC supply network. Otherwise, personnel will be exposed to the risk of an electric shock.
2. Adjustments, replacement of parts, maintenance and repair may be performed only by elec-
trical experts authorized by WORK Microwave.
To Next Page
Loading...