3.5 Installation
❖ The sterilizer should be set on level table or place; the front-end should be a little bit
higher then back-end(via front pads).
❖ The sterilizer cooling and vent area should not be jammed or blocked.
❖ Do not put any stuff on the top of the sterilizer.
❖ Do not put any stuff in front of the door, to avoid accident when open the door.
❖ Do not put any corrosive stuff near the sterilizer to avoid accident or risk.
3.6 Power Connection
❖ The sterilizer should be connected with a stable and separated power source.
❖ Power socket is at the back of the sterilizer.
❖ Please confirm the connection power is complied with specification of nameplate at the
back of sterilizer.
CAUTION: Do not bend the power wire to avoid damage of power wire.
Do not put any heavy stuff on the power wire to avoid damage of power wire.
Do not use other power wire to avoid damage of sterilizer.
Do not try to add the power wire to avoid accident and risk.
To Next Page
Loading...
