Chapter 9 Transportation and Storage
9.1 Preparation before Transportation and Storage
Shut off the power switch, unplug the cord, and make the sterilizer been cooled down
completely.
9.2 Draining
Drain water from reservoir and the condensate collector completely: insert the joint end of the
attached tube to drain connection. The spout on the left is the water spout used for the
“used-water out”, the one on the right is used for the “clean-water” drain spout.
9.3 Conditions for Transportation and Storage
❖ Temperature: -5 ℃ ~ +55℃
❖ Relative Humidity: ≤85%
❖ Atmospheric Pressure: 500HPa~1060HPa
9.4 Package
Package is used in transportation for protecting product, conveniently delivery and sales.
The sterilizer package requirement should as followed:
1. Product can not over 3/4 volume of package.
2. Product should be fix inside the package.
3. Package bag should be higher than product 6mm.
To Next Page
Loading...
