Drawing Explanation:
CAUTION: The door should be shut tightly before running program to avoid the danger.
ATTENTION: The “Load” code will twinkle if the door not closed. The sterilizer will not
run unless the door has been closed completely.
If the door has been opened during the cycle, the sterilizer will display
error code”Er06”. Press “START” to cancel alarm, and then close the door
to restart.
6.7 Starting a Program
Close the door completely, and press “Start/Stop” button to start a working cycle.
The sterilizer will heat, sterilize and drying articles automatically. The whole process will take
20-50mins. It depends on the articles being sterilized, the initial temperature, and the program
you selected.
The Process of Sterilization
Pre-heating: Display HE
Chamber will start to be pre-heating when turning on the power switch, and keeping the
chamber warm.
To Next Page
Loading...
