WARNING: Refer to qualified personnel for servicing.
Never use a wire brush, steel wool, abrasive material, or chloride-containing
products to clean door and chamber assembly.
“Caution hot surface. Avoid contact." ensure that the sterilizer is cooled
down fully before cleaning to avoid burns.
Cleaning after Liquid Loads
Biological media tends to boil at a higher rate than other liquids during venting. This causes
media to be spattered inside the chamber. Therefore, the chamber must be cleaned daily
when you are sterilizing media. Cleaning as follows:
❖ Allow unit to be cooled down.
❖ Wipe out chamber and door with a clean, damp cloth.
WARNING: Failure to keep the interior of the stainless steel chamber free of mineral
deposits and debris can cause premature failure of the sterilizer.
8.3 Weekly Maintenance (More Often If Necessary)
Cleaning Chamber, Trays and Rack
At least once a week, the trays and tray rack should be removed from the sterilizer chamber.
The trays, tray rack and chamber should be thoroughly cleaned to remove any deposits from
the surfaces.
Clean the trays, rack and chamber (especially the bottom of the chamber) with appropriate anti
biological cleaners. Wipe all residues from the surfaces with a dampened, lint-free cloth.
WARNING: To prevent from collection of mineral deposits and corrosion of chamber
components, use distilled water only as specified. Clean chamber after
each use if sterilizing saline solutions.
Cleaning water draining filter
Water draining filter (pic 8-1) might has been jammed by some dust because of use for a
long-term, so effect of vacuum and drying would be influenced. Some tiny impurity might be
deposited on the filter after a long-term use, blocking the filter, so as to influence the effect of
To Next Page
Loading...
