Warning Messages
975-0390-01-01 47
Error Code Condition Mode Action
E10
High battery voltage (> 15.5 V) AC shore power Check for external charging sources, such as an over voltage
alternator, and disconnect if necessary.
Confirm that the external charging source isnot the cause. The error may
be caused by the internal battery charger system. Call Xantrex for support.
E11
Over-temperature detected on
the AC transfer relay
AC shore power Reduce the loads connected to the AC outlet of the unit.
Check that the ventilation grille isnot blocked.
Check for ambient temperature and move the unit to a cooler location
whenever possible.
E12
Battery is bad or external DC load
is connected to the battery.
AC shore power Check the battery bank.
NOTE: The battery voltage did not rise above 5 volts DC after 1 minute or 10
volts DC after 15 minutes.
Check that the external DC load current consumption isbelow the charging
current setting.
Disconnect the DC load or increase the charger current setting.
For error code E01:
n the display screen and the alarm will turn off after 30 seconds
a
n after a five-minute shutdown delay
b
, the unit will immediately
stop inverting
For error code E12:
n the unit will stop charging and shut down, and
n the error code will show on the display screen briefly, and
n AC power will not pass through to the AC outlets.
For error codes E02 to E04: the unit will stop inverting.
a
Available in all models (including some PN: 806-1840-01) except Freedom HF 1500 and 1800 T.
b
Available only for the Freedom HF 1500 and 1800 T models.
To Next Page
Loading...
