Xerox 8825 User Manual

XEROX WIDE FORMAT COPY SYSTEM Main Menu • 129
A: Calibration Roll Drive Gear
12. Press the Exit key to return to the COMPONENT TESTS menu
screen.
The MOTOR COMMUNICATIONS test is for use by the Customer
Service Engineer only. However, user access is permitted in the event
that Service instructs the user to perform this test. This test allows the
Customer Service Engineer or user, if directed by the Service Engineer,
to run a motor communications loopback test to assist in diagnosing a
scanner problem.
When the Start key is press the message changes to STATUS:, then
after the test completes either a PASS or FAIL status is displayed. If the
status is FAIL, some test values will be displayed., and Service will be
required.
DOCUMENT MOTOR
COMMUNICATIONS
PRESS START TO BEGIN
This option allows you to stop and start the document handler motor.
When you select this option, the DOCUMENT MOTOR screen is
displayed.
To run the DOCUMENT MOTOR diagnostic:
1. Press the Menu key. The MAIN MENU screen is displayed.
MOTOR
COMMUNICATIONS
DOCUMENT MOTOR

Xerox 8825 Specifications

General

Brand	Xerox
Model	8825
Category	Printer
Language	English