Security
ColorQube 9301/9302/9303 Multifunction Printer 69
System Administrator Guide
Connect your card reader to the USB port.
If you are using Xerox
®
Secure Access, install the Xerox
®
Secure Access authentication server
software and configure it with user accounts. Refer to the Xerox
®
Secure Access Unified ID System
documentation for help.
Note: Accounts created on the Xerox
®
Secure Access server must match accounts stored in the printer
local database or in another network authentication server.
Setting Up Authentication for a Smart Card System
1. In CentreWare Internet Services, click Properties > Security > Authentication.
2. Click Setup.
3. Click Edit.
4. Under Authentication method on the machine's touch interface, select Smart Cards.
5. You can configure an alternate authentication method to allow users to access the printer without a
smart card. Under Alternate authentication method on the machine's touch interface, select
User Name / Password Validated Remotely on the Network.
6. Specify a method for the printer to authenticate users who access CentreWare Internet Services
from their computer. Under Authentication method on the machine's web user interface, select
User Name / Password Validated Locally on the Xerox Machine or User Name / Password
Validated Remotely on the Network.
7. Under Authorization information is used, select Locally on the Xerox Machine, or Remotely on the
Network.
8. Click Save.
9. Type the Feature Enablement Key that is included in the Common Access Card Enablement Kit, and
click Next.
10. Click Next again. A list of configuration settings appears at the bottom of the Xerox
®
Access Setup
page.
11. Click Edit to configure any settings that are marked in red text as Required; Not Configured.
Configuring Domain Controller Settings
To Next Page
Loading...
Need help?
General
