The Scanner’s Web Interface Xerox
®
D70n Scanner
User Guide 9-5
MAC & IP Filtering
The devices contain a static host-based firewall that prevents unauthorized network access based
on IP address Mac address. Filtering rules can be set by the Administrator using the Web Interface.
An authorized Administrator can create rules to (filter / allow) for ALL or a range of IP addresses. In
addition, an authorized Administrator can specify Mac addresses to filter/allow.
1. To Enable/Disable Filtering, use "Filter" control.
2. To change which address to be allowed or filtered use "Filter Mode" control. When it is set to
"Disable" all the addresses or range of addresses will be filtered. When it is set to "Enable", only
the addresses or range of addresses specified will be allowed. All others will be filtered.
3. To filter a single IP address, enter it in both "Start IP Address" and "End IP Address" controls.
4. To filter a range of IP addresses, specify start and end address.
5. Maximum of 5 IP address ranges can be specified
6. To filter a MAC address enter it in one of the 10 rows of the MAC Address table.
7. Press the "Update" button to save your settings.
To Next Page
Loading...
Need help?
General