Xerox Phaser 3260 User Manual

June 2014
4-24
Xerox® Phaser® 3052/3260 Service Manual
REP 1.14, REP 1.15
Repairs
NOTE: When replacing the Actuators make sure the Spring is correctly seated in the cutout in
the frame (Figure 5).
Figure 5 Actuator Spring Cutouts (Bottom View)
REP 1.15 Feed and Forward Roll Assembly
Parts List on PL 4.4
Removal
1. Switch Off the Printer and disconnect the Power Cord.
2. Remove the Paper Cassette.
3. Remove the Left and Right Side Covers (REP 1.2).
4. Set the printer so the Front of the printer facing up.
NOTE: The Feed and Forward Roll Assembly screws are different from the Bottom Bar
screws. Observe the screw locations for correct replacement.
5. Remove the Bottom Bar (2 screws) (Figure 1).
Figure 1 Removing the Bottom Bar (Bottom View)
6. Remove the Feed and Forward Roll Assembly (Figure 2):
a. Remove the screws (2)
b. Pull the right side of the assembly out, then slide the assembly out to the right.
Spring Cutouts
Screws

Xerox Phaser 3260 Specifications

General

Print Technology	Laser
Print Speed	Up to 29 ppm
First Page Out	As fast as 8.5 seconds
Duplex Printing	Automatic
Monthly Duty Cycle	Up to 30, 000 pages
Output Capacity	150 sheets
Processor Speed	600 MHz
Memory	128 MB
Supported Operating Systems	Windows, Mac OS, Linux
Connectivity	USB 2.0
Input Capacity	250 sheets
Media Sizes Supported	A4, A5, A6, B5, Executive, Folio, Legal, Letter, Oficio
PDL	PCL 6, PCL 5e, PostScript 3