Xerox Phaser 4510 - Page 67

Printing on Specialty Media
Phaser® 4510 Laser Printer
3-31
8. Insert the tray into the tray slot, and push the tray completely into the printer.
9. On the control panel, select the transparency type:
a. Select
Paper Tray Setup, and then press the OK button.
b. Select
Tray 2 Paper, Tray 3 Paper, or Tray 4 Paper, and then press the OK button.
c. If the correct transparency size and type are displayed as the current setup, select
Use
current setup
and then press the OK button. If the correct media type and size are not
displayed, change the setup:
■ Select Change setup, and then press the OK button.
■ Select Transparency from the list displayed, and then press the OK button.
■ Select the appropriate paper size, and then press the OK button.
10. In the printer driver, select either Transparency as the paper type or the appropriate tray
as the paper source.
4510-102