Maintenance
Phaser 6600 Color Printer 139
User Guide
3. Remove the paper from the paper tray.
4. Keep the paper wrapped and away from humidity and dirt.
5. Lift and carry the printer as shown in the illustration.
CAUTION: Failure to repackage the printer properly for shipment can result in damage not
covered by the Xerox
®
Warranty, Service Agreement, or Total Satisfaction Guarantee. The
Xerox
®
Warranty, Service Agreement, or Total Satisfaction Guarantee do not cover damage to
the printer caused by improper moving.
When moving the printer, do not tilt it more than 10 degrees to the front, back, left, or right. Tilting the
printer more than 10 degrees can cause toner spillage.
Note: When moving the printer over a long distance, remove the imaging units and toner
cartridges to prevent toner from spilling. Pack the printer inside a box. For a repacking kit and
instructions, go to www.xerox.com/office/6600support.
After moving the printer:
1. Reinstall any parts you removed.
2. Reconnect the printer to the cables and power cord.
3. Plug in and turn on the printer.
To Next Page
Loading...
