Installation and Setup
30 Phaser 6600 Color Printer
User Guide
Installation and Setup Overview
Before printing, your computer and the printer must be plugged in, turned on, and connected.
Configure the initial settings of the printer, then install the driver software and utilities on your
computer.
You can connect to your printer directly from your computer using USB, or connect over a network
using an Ethernet cable or wireless connection. Hardware and cabling requirements vary for the
different connection methods. Routers, network hubs, network switches, modems, Ethernet cables,
and USB cables are not included with your printer and must be purchased separately. Xerox
recommends an Ethernet connection because it is typically faster than a USB connection, and it
provides access to CentreWare Internet Services.
Note: If the Software and Documentation disc is not available, you can download the latest
drivers from www.xerox.com/office/6600drivers.
See also:
Selecting a Location for the Printer on page 31
Choosing a Connection Method on page 32
Connecting the Printer on page 32
Configuring Network Settings on page 43
Installing the Software on page 78
To Next Page
Loading...
Need help?
General
Weight and Dimensions
