Xerox Phaser 7100

Features
Phaser 7100 Color Printer 23
User Guide
Energy Saver Mode
Use Energy Saver options to conserve power, and set how long the printer remains idle before changing
modes. Ready mode is where the printer is at full power. Low Power mode is where power to the fuser
and other areas are turned off. Sleep mode is the lowest power state the printer can obtain without
shutting off.
Setting Up Energy Saver Modes
1. At the control panel, press Menu.
2. Navigate to Admin Menu, then press OK.
3. Navigate to System Settings, then press OK.
4. Navigate to Low Power Mode, then press OK.
5. To turn on or off Low Power mode, use the arrow buttons to select Enabled or Disabled, press OK,
then press Back.
6. Navigate to Low Power Timer, then press OK.
7. To set the delay before the printer enters Low Power mode, use the arrow buttons to set the time,
press OK, then press Back. The range is 1–240 minutes.
8. Navigate to Sleep Mode Timer, then press OK.
9. To set the delay before the printer enters Sleep mode, use the arrow buttons to set the time, then
press OK. The range is 1–240 minutes.
Note: The Low Power Timer and Sleep Mode Timer are independent, in that both start at the same
time.
10. To return the printer to Ready, press Menu.