Paper and Media
Phaser 7100 Color Printer 47
User Guide
2. Load the paper in the tray:
With Duplex Unit Without Duplex Unit
Insert the paper long-edge feed, with the print side face
up and the top edge to the right. Load hole punched
paper with the holes facing into the printer.
Insert the paper long-edge feed, with the print side face
down and the top edge to the right. Load hole punched
paper with the holes facing you.
Insert large-format paper short-edge feed, with the print
side face up and the top edge facing into the printer.
Load hole punched paper with the holes to the left.
Insert large-format paper short-edge feed, with the print
side face down and the top edge facing you. Load hole
punched paper with the holes to the left.
3. Adjust the width guides until they touch the edges of the paper.
4. If no paper change settings are necessary at the control panel prompt, press Back. To change the
size, type, and color, press OK and follow the prompts.
To Next Page
Loading...
Need help?
General