Xerox Phaser 7400

Phaser® 7400 Color Printer
A-3
Operational Safety
Your printer and supplies were designed and tested to meet strict safety requirements. These
include safety agency examination, approval, and compliance with established environmental
standards.
Your attention to the following safety guidelines helps to ensure the continued, safe operation
of your printer.
Printer Location
Place the printer in a dust-free area within a temperature range of 50° F to 90° F (10° C to
32° C) and within the following humidity range:
■ Optimal Print Quality: 50% – 70%
■ Operating: 20% – 80%
Printer Clearance
Place the printer in an area where there is adequate space for ventilation, operation, and
servicing. The recommended minimal spacing is:
Overhead Clearance:
■ 60.96 cm (24.0 in.) above the printer without the finisher
■ 60.96 cm (24.0 in.) above the printer with the finisher
Total Height Requirements:
■ Printer: 46.2 cm (18.0 in.)
■ 550-Sheet Feeder: 10.8 cm (4.25 in.)
■ 1650-Sheet High-Capacity Feeder: 40.1 cm (15.8 in.)
■ Finisher: 100.0 cm (39.4 in.)
Other Clearances:
■ 15.2 cm (6 in.) behind the printer
■ 50.8 cm (20 in.) in front of the printer
■ 50.8 cm (20 in.) on the left side of the printer, without the finisher, for the left-side output
tray and media
■ 101.6 cm (40 in.) on the left side of the printer with the finisher installed
■ 50.8 cm (20 in.) on the right side of the printer for Tray 1 (MPT) and media