Basic Regulations
Xerox has tested this printer to electromagnetic emission and immunity standards. These standards
are designed to mitigate interference caused or received by this printer in a typical office
environment.
RReegguullaattoorryy IInnffoorrmmaattiioonn ffoorr 22..44--GGHHzz aanndd 55--GGHHzz
WWiirreelleessss NNeettwwoorrkk AAddaapptteerrss
This product contains a 2.4-GHz and 5-GHz Wireless LAN radio transmitter module that complies with
the requirements specified in FCC Part 15, Industry Canada RSS-210, and European Council Directive
2014/53/EU. Radio Frequency (RF) output power of this device will not exceed 20 dBm in either fre-
quency band.
Operation of this device is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause unde-
sired operation.
Changes or modifications to this device not specifically approved by the Xerox Corporation may void
the user's authority to operate this equipment.
UUnniitteedd SSttaatteess FFCCCC RReegguullaattiioonnss
This equipment has been tested and found to comply with the limits for a Class A digital device, pur-
suant to Part 15 and Part 18 of the FCC Rules. These limits are designed to provide reasonable protec-
tion against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy. If the equipment is not installed
and used in accordance with these instructions, it can cause harmful interference to radio communica-
tions. Operation of this equipment in a residential area is likely to cause harmful interference. Users
are required to correct the interference at their own expense.
If this equipment does cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not approved by Xerox can void the authority of the user
to operate this equipment.
WARNING: To ensure compliance with Part 15 and Part 18 of the FCC rules, use shielded inter-
face cables.
242
Xerox
®
VersaLink
®
C8000/C9000 Color Printer
User Guide
Regulatory Information
To Next Page
Loading...
Need help?
General
